[VPS linux] Cài đặt Nginx trên virtualmin

Introduction to Nginx

Nginx is a lightweight webserver that supports most of the functionality of Apache, but is faster and uses less memory. It is suited to websites that have a large amount of static content, or virtual machines with limited memory. For more information, see http://wiki.nginx.org/Main
Installing Nginx Support

Switching a system from the Apache webserver (installed by default by Virtualmin to Nginx should only be done if no virtual servers with websites have been created yet. Ideally the change should be done on a freshly installed system, running RHEL 6.0, CentOS 6.0 or Debian 6.0 or later. Virtualmin version 3.89 or above is also required.
The steps to remove Apache and install Nginx are :

1. Shut down Apache with the command /etc/init.d/httpd stop ; service httpd off (on RHEL or CentOS), or /etc/init.d/apache2 stop ; update-rc.d apache2 remove (on Debian).
2. Install Nginx with the command yum install nginx (on RHEL or CentOS) or apt-get install nginx (on Debian).
3. Start the Nginx webserver with the command /etc/init.d/nginx start
4. Install Virtualmin's Nginx plugin with the command yum install wbm-virtualmin-nginx wbm-virtualmin-nginx-ssl (on RHEL or CentOS) or apt-get install webmin-virtualmin-nginx webmin-virtualmin-nginx-ssl (on Debian).

Once this is done, you can configure Virtualmin to use it as follows :

1. Login to Virtualmin as root, and go to Webmin -> Servers -> Nginx Webserver and make sure that Nginx and its configuration files are found.
2. If not, click on the Module Config link and set the config and command paths correctly.
3. Return to Virtualmin, and go to System Settings -> Features and Plugins.
4. Un-check the "Apache website" , "SSL website" and "DAV Login", "Mailman", "Protected web directories", "AWstats reporting" and "Subversion repositories" features.
5. Check the "Nginx website" and "Nginx SSL website" features, then click "Save".
6. If Virtualmin reports that any other features cannot be used without Apache, go back and de-select them too.
7. Go to the System Information page and click Refresh system information in the top right.
8. Verify that Nginx is shown as running in the "Status" section.

Using Nginx

Once Nginx support has been configured, you should be able to create virtual servers just as you would with Apache. However, on the Create Virtual Server page you will need to select Enable Nginx website? in the Enabled features section, instead of Enable Apache.
When creating a domain from the command-line API, you will need to use the --virtualmin-nginx flag instead of --ssl . For SSL websites, you will need to use --virtualmin-nginx-ssl instead of --ssl .
Similarly, when creating a domain via the remote API, you will need to use the virtualmin-nginx= parameter instead of web= .
Limitations of Nginx

Nginx as configured by Virtualmin lacks some features of Apache, such as :

• Only one virtual server can have SSL enabled per IP address, even if a wildcard or UCC certificate would potentially allow multiple SSL sites to share the same IP.
  
• Nginx does not support CGI, so any applications or Virtualmin scripts that use CGI will not work. Virtualmin should prevent the installation of scripts that require CGI, mod_perl or Apache-specific features.
  
• PHP can only be executed via FastCGI, and all PHP scripts run with domain owner permissions. Execution via CGI or mod_php is not supported. For PHP to work, Virtualmin will setup a PHP FastCGI server process that Nginx communicates with for each virtual server.
  
• Only one PHP version is supported, and Virtualmin will pick the highest version available on the system. This typically means that PHP v4 scripts cannot be run.